Westell Inc. CSI-DSP85-U7C ユーザーズマニュアル

-17-

When login is complete the user is brought to the system status page. The links shown in the
navagation box on the left are activated by clicking on them.

Primary access to the repeater is  gained using a LAN connection and a web browser
program such as Firefox by Mozilla, or Internet Explorer from Microsoft.  The repeater ships
with the default IP address of 192.168.1.100, but it can be changed later if required.

If connecting directly to the repeater from a laptop or PC with a crossover CAT-5E cable or
over a LAN the user types the IP address of the repeater into the browser address line to
connect. 

(Note: Most users will need to update the TCP/IP settings on their computer to enable

connection to a host that has a static IP.  Select “Use the following IP Address” and enter the IP
Address as follows: 192.168.1.x, where “x” = any number from 2 to 254 inclusive other than
100. The subnet mask is 255.255.255.0.  Questions pertaining to these settings should be
referred to the user’s IT department or you may refer to the Additional Tips section at the end
of this manual.)

  When connection is made the user will be prompted for a user name and

password. For the purpose of the GUI session, the default user name is webuser and the
password is csi1234.  This can also be changed as required. Internet access is not required
to use the GUI.  

(Note: If you are connecting using a laptop, verify that your Ethernet port is

powered.  Some laptops will not allow Ethernet connection when on battery power. If this is
the case with the laptop you are using you will need to plug it in or update the power settings.)