Pelican Accessories WAVE1 ユーザーズマニュアル

 

WaveStation has the ability to use 6 different channels to ensure 
there is  no signal interference.   
NOTE:  Leave these settings set to the factory settings unless 
you are experiencing signal interference. 
There is a channel selector on the bottom of the Receiving Unit 
and inside the battery compartment of the Docking Unit.  If the 
channels are changed they must be the same on both units. 

 

Channel 1 – Only DIP switch 2 ON 
Channel 2 – Only DIP switch 3 ON 
Channel 3 – Only DIP switch 4 ON 

Channel 4 – Only DIP switch 1 ON 
Channel 5 – DIP switches 1 & 3 ON
Channel 6 – DIP switches 1 & 4 ON

 

(Note:  Only 1 of  the DIP switches 2,3,4 can ever be ON at any one time.)

 

 

 

If you are experiencing a weak signal first check your batteries, if 
it continues change the channel on both WaveStation unit s. 

 

If WaveStation is not functioning properly confirm the Receiver 
unit is plugged in and the controller(s) are properly connected to 
the Docking Unit. 

 

 

 

Changes or modifications not expressly approved by the manufacture 
could void the user's authority to operate the equipment.  This device 
complies with Part 15 of the FCC Rules.  Operation is subject to the 
following two conditions; (1) this device may not cause harmful 
interference, and (2) this device must accept any interference received, 
including interference that may cause undesired operation.