Honeywell International Inc. 7400-476 ユーザーズマニュアル
4 - 9
The decoding method used in a particular scanning or image capture application is determined by the application developer and
cannot be changed by the end user. The imaging capabilities of both decode methods help simplify terminal operation and
enhance data capture productivity.
cannot be changed by the end user. The imaging capabilities of both decode methods help simplify terminal operation and
enhance data capture productivity.
When reading linear 1D and 2D bar codes using ALD, the imager’s aiming beam should be centered horizontally across the bar
code to achieve a positive read.
code to achieve a positive read.
When reading all bar code types using full area imaging, the aiming beam should be centered horizontally across the bar code
to achieve the best read, though a positive read can be obtained from most any position.
to achieve the best read, though a positive read can be obtained from most any position.
Reading A Bar code
1. Press the ON/SCAN button on the 7400 or the Scan Trigger on the 7450 to project the scanner’s bright red or green aiming
beam. The aiming beam should be oriented in line with the bar code to achieve the quickest read. A range of 4-10 inches
(10-25 cm) is recommended.
(10-25 cm) is recommended.
2. Center the aiming beam over the bar code. The red SCAN LED illuminates when the user presses the ON/KEY key, and the
green DECODE LED illuminates when a bar code is successfully decoded and the terminal beeps.
Scan LED
Decode LED