Honeywell International Inc. CS22A ユーザーズマニュアル

©2010 Honeywell International Inc.   All rights reserved. 

ACC-PT-QS Rev (a) 4/10

1. Turn on the computer (laptop/desktop).

2. Plug the interface cable into the Access Point first and then into the appropriate port on the computer.  The Page button 

lights up when the connection is made.

Only one scanner may be linked to the Access Point at a time.  To link a different scanner to the Access Point, use the new scan-
ner to scan the Linking bar code on the Access Point.  That unlinks the first scanner and links the second one.

The scanner is in communication with the Access Point even if it is not transmitting bar code data.  If you take the linked 
scanner out of range of the Access Point, communication with the module will be lost and you will have to reconnect the 
scanner to the Access Point.  To reconnect the scanner, scan the Linking bar code.

If the scanner turns off due to a low battery, you can change the battery without losing the link with the Access Point, pro-
vided the scanner is in range.  A few seconds after the scanner powers up, the scanner relinks to the module.

  

www.honeywellaidc.com

 for additional information about charging the batteries.

3. Scan the linking bar code on the top of the Access Point to establish a connection 

between the Access Point and the scanner.  The scanner emits a short beep and flashes 
the green LED to confirm a connection with the Access Point.  The Access Point’s Page 
button remains blue.

Page button