Adtran TRC6410L2X ユーザーズマニュアル

Section 4  Network Turnup Procedure

TRACER 6000 Series Integrated System Manual

 52

Copyright © 2005 ADTRAN, Inc.

612806420L1-1D

Individual access modules insert in the back of the chassis. Two phillips-head screws hold the modules in 
place for added security. To install network modules, follow the steps outlined below.

The physical T1 interfaces are provided using four RJ-45 ports located on the module. Straight-through T1 
interface cables can be used to interface to any standard T1 DTE device (not supplied).

The physical Ethernet interfaces are provided using four RJ-45 jacks. Ethernet cables are not supplied with 
your shipment. Connect any standard Ethernet device to one of the switch ports located on the rear of the 
unit.

Ω

The physical E1 interfaces are provided using four RJ-45 ports located on the module. Straight-through E1 
interface cables can be used to interface to any standard E1 DTE device (not supplied).

1.

Remove power from the unit.

2.

Remove the blank panel plate (if necessary).

3.

Slide the network module into the network slot until the module is firmly seated 
against the front of the chassis. 

4.

Secure the screws at both edges of the module.

5.

Install the optional hardware components (when necessary). For example, for 
the E1 network module, an optional BNC breakout panel is available.

6.

Connect the cables to the associated device(s).

7.

Restore power to the unit.