Adtran TRC6410L2X ユーザーズマニュアル
612806420L1-1D
Copyright © 2005 ADTRAN, Inc.
95
DLP-2
Logging into the TRACER 64x0
Introduction
Once you are connected to the TRACER 64x0, you must log into the system to gain access to the
management and provisioning functions. This DLP assumes you are connected to the TRACER 64x0 and
provides specific steps for logging into the system.
management and provisioning functions. This DLP assumes you are connected to the TRACER 64x0 and
provides specific steps for logging into the system.
Prerequisite Procedures
see
To prevent electrical shock, do not install equipment in a wet location or during a
lightning storm.
lightning storm.
Electronic equipment can be damaged by static electrical discharge. Before handling it,
put on an antistatic discharge wrist strap to prevent damage to electronic components.
Place equipment in antistatic packing material when transporting or storing. When
working on equipment, always place it on an approved antistatic mat that is electrically
grounded.
put on an antistatic discharge wrist strap to prevent damage to electronic components.
Place equipment in antistatic packing material when transporting or storing. When
working on equipment, always place it on an approved antistatic mat that is electrically
grounded.
After the IP parameters have been provisioned (see DLP-3, Setting IP Parameters for the
TRACER 64x0, on page 97), you can also log in via Telnet.
TRACER 64x0, on page 97), you can also log in via Telnet.