Unitech Electronics Co. Ltd. RM300F ユーザーズマニュアル
GPIO
The GPIO menu is shown in the following figure.
The General purpose GPIO can be configured as Input or Output and the corresponding state
is also reflected. The Refresh button can be used to update the states of the GPIOs configured
as input. The greyed state boxes reflect the Input State. When configured as GPOs the state
becomes user selectable.
is also reflected. The Refresh button can be used to update the states of the GPIOs configured
as input. The greyed state boxes reflect the Input State. When configured as GPOs the state
becomes user selectable.
The ARM GPOs can be set Low and High via the ARM GPO control box.
NV
Mem
The NV Mem menu is shown in the following figure.
The following are the available Command functions:
1. Load Binary -
The NV Mem can be used to write to any of the NV memory, but the primary function is for
firmware downloads.
1. Load Binary -
The NV Mem can be used to write to any of the NV memory, but the primary function is for
firmware downloads.
There are three main inputs to this NV Mem update function:
A) Input File – To select a file, a dialog will prompt the user to select the binary file. Once
A) Input File – To select a file, a dialog will prompt the user to select the binary file. Once
selected the file is cached into the IndyTool application and the file properties are displayed:
Name: harvemacR1000.a79 Date: 2/16/2010 7:58:15 PM Size: 162996 bytes
Name: harvemacR1000.a79 Date: 2/16/2010 7:58:15 PM Size: 162996 bytes
23
Copyright 2012 Unitech Electronics Co., Ltd. All rights reserved. Unitech is a registered trademark of Unitech Electronics Co., Ltd.