Cidco Communications Corporation CL915 ユーザーズマニュアル
8
B
ATTERY
I
NSTALLATION
1. Slide open the battery compartment door on the back of the
handset.
2. Securely plug in the wire and then lay the battery pack into the
battery compartment.
3. Close the battery compartment door.
4. Place the handset on the base unit cradle.
N
OTE
Once you have installed the battery pack and placed the
handset on the base, you will hear a tone indicating the
handset has connected with the base and will charge
successfully. In addition, the charge LED on the base
illuminates when the handset is properly making contact
with the charge terminals.
handset on the base, you will hear a tone indicating the
handset has connected with the base and will charge
successfully. In addition, the charge LED on the base
illuminates when the handset is properly making contact
with the charge terminals.
W
HEN
THE
BATTERY
NEEDS
CHARGING
■ The phone will beep.
■ The display will show BATTERY LOW.
■ The display will show BATTERY LOW.
W
HEN
TO
PURCHASE
A
NEW
BATTERY
PACK
■ If the battery lasts only a few minutes even after a full charge,
the usable life of the battery has expired and it needs to be
replaced.
replaced.
R
INGER
S
ETTING
1. To set the ringer level to high or low on the handset, press
REVIEW/VOLUME
when the handset is idle.
2. To turn the handset ringer ON or OFF, set the RINGER switch located
on the handset to the desired position.
Ringer tones can be programmed on the handset when you are program-
ming setup functions.
ming setup functions.
CL915.book Page 8 Friday, May 4, 2001 11:35 AM