Fujitsu Technology Solutions GmbH SCENIC8501 ユーザーズマニュアル

Installing and removing a board

32

A26361-K516-Z100-1-7619

²

").

3

4

a

1

2

5

6

²

Press on the clip in the direction of the arrow (1) and remove it (2).

²

Remove the rear slot cover plate from the slot (3).

Do not dispose of the rear slot cover plate. For cooling, protection against fire and in order
to comply with EMC regulations, you must refit the rear slot cover plate if you remove the
board.

²

Take the new board out of its packaging.

²

Make the required settings for the board.

²

Push the board into the slot (4).
Ensure that the end of a long board without angle bracket fits into the corresponding guide of
the system unit. Ensure also that the point of the angle bracket slots into guide (a).

²

Press the board into the slot so that it engages.

²

Replace the clip (5) which fixes the board. Make sure that the clip engages when released (6).

²

If necessary, plug the lines on the board.

²

If you have installed or removed a PCI board, please check in the 

 the settings

for the relevant PCI slot. If necessary, change the settings. Further information is provided
in the documentation for the PCI board.