Murata Electronics North America DNT500P ユーザーズマニュアル
DNT500
2008 by RF Monolithics,
Inc.
50
M-0500-0000 Rev D
6. Demonstration Procedure
The procedure below provides a quick demonstration of the DNT500 using a
DNT500DK development kit:
DNT500DK development kit:
1.
Confirm that each DNT500P is installed correctly in an interface board, and that
the U.FL jumpers between the DNT500P radios and the interface boards are in-
stalled. Also confirm that a dipole antenna is installed on each interface board,
and that J14 has a jumper block installed on each interface board. See Figures
5.4.1, 5.4.2 and 5.4.3 above.
the U.FL jumpers between the DNT500P radios and the interface boards are in-
stalled. Also confirm that a dipole antenna is installed on each interface board,
and that J14 has a jumper block installed on each interface board. See Figures
5.4.1, 5.4.2 and 5.4.3 above.
2.
Attach each transceiver/interface board to a computer with the DNT500 Wizard
utility program installed. Place the transceivers at least 3 feet (one meter) apart.
utility program installed. Place the transceivers at least 3 feet (one meter) apart.
3.
Start the DNT500 Wizard utility program on both computers.
4.
On each computer, press the Connect button on the Wizard window. This will
open a serial port setup dialog box. Set the baud rate to 115.2 kb/s and select the
COM port the DNT500 is connected to. Parameter values on the left of the Wiz-
ard main window and on the Transceiver Setup tab will fill in.
open a serial port setup dialog box. Set the baud rate to 115.2 kb/s and select the
COM port the DNT500 is connected to. Parameter values on the left of the Wiz-
ard main window and on the Transceiver Setup tab will fill in.
5.
Select the RF Test tab on the Wizard. A message placed in the Transmit Window
is sent to the specified MAC address each time the Apply button is pressed. Mes-
sages received are displayed in the lower text box. The receive message text box
can be cleared with the Clear button.
is sent to the specified MAC address each time the Apply button is pressed. Mes-
sages received are displayed in the lower text box. The receive message text box
can be cleared with the Clear button.