Murata Electronics North America HN1010 ユーザーズマニュアル

HN-1510 Outdoor Base/Remote Station 

14  

HopNet Family of Products 

M-2410-0010, Rev - 

Four LED indicators are included on the front panel to provide the status of the HN-
1510 Indoor Base/Remote station. See the illustration below. These built-in flow 
control indicators allow you to quickly check the operational status.  

 

 

The table below describes the function of each LED. 

 

PWR 

Green 

Continuous DC power is applied 

TX 

Red 

RS-232 signal input 

RX 

Red 

RS-232 signal output 

CD 

Red 

Normal operation is asserted 

The HN-1510 is supplied with a 110/ 220 wall mount power supply. However, you 
can operate the HN-1510 from any well-filtered 7.5 to 24 VDC power source. The 
power supply should be capable of providing 500 milliamperes of current.  

The indoor base station uses a separate 2-pin power connector that accepts  
7.5 to 24 VDC. Power connects to the 2-pin connector on the front panel of the 
transceiver. A polyfuse is on the transceiver board to protect against short circuits. 

The RF signal is brought in on a standard female TNC jack connector located on the 
front panel.  

Use the following guidelines when installing the antenna: 
•  Strictly follow the antenna manufacturer’s installation instructions for proper 

operation of the antenna.  

•  Be sure to use proper polarization for any system using a gain type antenna. If you 

orient the antenna with the wrong polarization, a signal reduction of greater than 20 
dB could result. 

•  Use a low-loss feedline with the HN-1510. Keep the feedline as short as possible to 

minimize signal loss.  

•  Use proper care when installing the feedline to prevent damage. Do not twist, 

stretch, or kink the cable.  

•  Be sure to securely fasten the cable and only use connectors that have been 

recommended by the cable manufacturer.  

PWR       TX         RX          CD