The Whistler Group BU01C ユーザーズマニュアル
5
CHARGING CAMERA ASSEMBLY
The Camera under normal use, will maintain a charge with
exposure to sunlight. A battery status indicator is provided
on the monitor when the camera is in use. If you’re storing
your vehicle in a garage for more than a one month, or are
otherwise not exposing the Camera to sunlight on a regular
basis, you may need to recharge it via the Micro USB charge
port.
exposure to sunlight. A battery status indicator is provided
on the monitor when the camera is in use. If you’re storing
your vehicle in a garage for more than a one month, or are
otherwise not exposing the Camera to sunlight on a regular
basis, you may need to recharge it via the Micro USB charge
port.
To recharge the Camera:
1. If attached to vehicle, please remove.
2. Connect the supplied USB cord to the Micro USB port of
2. Connect the supplied USB cord to the Micro USB port of
the camera assembly.
3. Plug the USB cable into any standard USB charger with an
output rating of 500ma or higher.
4. Charge 4 to 5 hours if the battery was completely depleted
5. Once charged, Re-install the Camera assembly to your
5. Once charged, Re-install the Camera assembly to your
vehicle.
NOTE: It is recommended to fully charge your Camera before
installing on the vehicle.
installing on the vehicle.
Tips to optimize the solar charge:
1. Be sure that the solar panels are are clean, and dust/dirt-
free.
2. Park in a location where the sun is or will be shining directly
on the solar panels for at least 1-2 hours a day.
3. One hour of good sunlight daily offsets the daily power
consumption of the Camera.