Wacom DTU-710 ユーザーズマニュアル
6
USB connector
Installation
LCD Monitor Installation
First install the monitor portion of DTU-710. Do not connect the USB cable or serial data cable
until you procede to the step " ".
until you procede to the step " ".
Turn off your computer.
IMPORTANT: Never connect or disconnect the DVI video cable or power cable while your
computer or DTU-710 is powered on. This can damage the LCD display or video card.
Connect the DVI-to-DVI cable or DVI-to-VGA cable between DTU-710 and your computer.
Set the DVI/VGA switch. Move it up for analog (VGA) mode, and move it down for digital
(DVI) mode.
Connect the AC adaptor to DTU-710.
IMPORTANT
■
Do not use any cable that did not come
with DTU-710; use of an improper cable
may damage DTU-710.
may damage DTU-710.
■
Make sure your graphics card has a VGA
or DVI connector, and that you correctly
set the DTU-710 Analog (VGA)/Digital
(DVI) switch for the graphics card you
are using. The use of an improper video
card may damage DTU-710.
set the DTU-710 Analog (VGA)/Digital
(DVI) switch for the graphics card you
are using. The use of an improper video
card may damage DTU-710.
■
Do not connect or disconnect the video
or power cable while DTU-710 or your
computer are turned on; this can damage
the LCD display or computer video card.
computer are turned on; this can damage
the LCD display or computer video card.
DVI-I connector
DVI/VGA switch
DC input
RS-232C connector
Cable guides
to AC outlet
Ground
Video card
DVI-DVI or DVI-VGA cable
To USB port
Rear Panel of your computer
To serial port
Connect one cable only.
DTU-710_EN.indd 6
04.7.20 8:31:35 PM