Orion Engineering Inc DBRS201 ユーザーズマニュアル
MOUNTING THE RADAR SENSOR
Steps for mounting your Radar Sensor are given below.
A. Be sure the tractor is on a level surface while installing the Radar
Sensor.
B. In selecting the proper position to mount your Radar Sensor, the
following considerations should be made:
1. For optimum performance, the Radar Sensor should be mounted on
the tractor in a location which is BETWEEN crop rows.
the tractor in a location which is BETWEEN crop rows.
2. The ideal location for the Radar Sensor would be near the center of
the tractor; this protects the Sensor from mud and other flying debris.
the tractor; this protects the Sensor from mud and other flying debris.
3. If this ideal location is not possible, select an alternate mounting
location for the Radar Sensor. The Sensor has been designed to func-
tion in a wide variety of locations on the tractor.
tion in a wide variety of locations on the tractor.
C. When installing the Radar Sensor, follow these rules:
1. The Radar Sensor must have an unobstructed view of the ground.
2. The Radar Sensor must be at a height of approximately 18-36
inches from the center of the gun to the ground.
inches from the center of the gun to the ground.
3. The Radar Sensor face must be mounted so the face of the gun is
parallel to level ground.
parallel to level ground.
4. Align the top of the Sensor Mount, level with the ground by using a
bubble level. This will insure that the Radar Sensor is at the proper
position for optimum operation.
bubble level. This will insure that the Radar Sensor is at the proper
position for optimum operation.
CHANGING DIRECTION OF TRAVEL
The radar sensor bracket is designed so the radar sensor can be
mounted in two different configurations.
mounted in two different configurations.
Level face of sensor with ground
(Top view of bracket with radar sensor installed)
The sensor can be installed so that the bracket may be mounted to the
side of the vehicle or to the front (or rear) of the vehicle. Remove the
cover plater screws and orient the sensor to match one of the pictures
below. The arrows indicate the direction of travel.
side of the vehicle or to the front (or rear) of the vehicle. Remove the
cover plater screws and orient the sensor to match one of the pictures
below. The arrows indicate the direction of travel.
Use this configuration
when mounting to the side
of a vehicle.
when mounting to the side
of a vehicle.
Use this configuration
when mounting to the
front or rear of a vehicle.
when mounting to the
front or rear of a vehicle.
Warranty
This System is under warranty against defects in material or
workmanship for a period of 1 year from the date of retail sale.
workmanship for a period of 1 year from the date of retail sale.
Defective monitors must be returned to the place of purchase within the warranty period.
Components will be replaced or repaired at factory discretion. This warranty applies only to
those systems which have been installed in accordance with published instructions.
those systems which have been installed in accordance with published instructions.
This warranty is in lieu of all warranties, expressed or implied, and the manufacturer
expressly disclaims all other warranties, including without limitations any implied warranties of
merchantability and fitness for a particular purpose.
merchantability and fitness for a particular purpose.
The manufacturer liability under this warranty shall not exceed the cost of the product.
Under no circumstance shall the manufacturer be responsible for equipment on which it’s monitors
are installed, field service calls relating to this equipment or for indirect, consequential or
special damages.
are installed, field service calls relating to this equipment or for indirect, consequential or
special damages.
Side of vehicle
Front or rear
TRAVEL
TRA
VEL
Tabs indicate direction of radar
beams
beams