Proxim Wireless Corporation XB92WFR ユーザーズマニュアル
Advanced Configuration
Tsunami
®
800 & 8000 Series - Software Management Guide
104
After configuring the required parameters, click OK and then COMMIT.
: Reboot the device, if you have changed any of the Wireless Interface parameters with an asterisk(*) symbol.
5.4.3.2 Sync
WORP Sync is a TDMA (Time Division Multiple Access) based implementation of the Proxim’s proprietary Wireless Outdoor
Routing Protocol which eliminates the co-location interference. With WORP Sync, all the BSU’s transmission and reception are
time-synchronized by means of GPS Synchronization techniques. This eliminates the co-location interference and improves
the overall performance of the network.
Routing Protocol which eliminates the co-location interference. With WORP Sync, all the BSU’s transmission and reception are
time-synchronized by means of GPS Synchronization techniques. This eliminates the co-location interference and improves
the overall performance of the network.
: Sync tab is applicable only for a BSU and by default, it is in disabled state. Sync Status can be set to Enable/Disable by
selecting an option from the drop-down menu.
For a BSU, Set the Sync Status to Enable, to configure or modify the Sync parameters.
Under the Sync tab, by default Compatibility is set to Proxim. Using the drop-down menu you can also select
Cambium-PMP or ePMP. Based on the option selected, the corresponding WORP Sync screen appears as shown below.
Cambium-PMP or ePMP. Based on the option selected, the corresponding WORP Sync screen appears as shown below.
Legacy Mode
By default, Legacy Mode is disabled. When enabled, the MP 800 & 8000 BSU and SU devices can
inter-operate with the legacy products of the Tsunami
inter-operate with the legacy products of the Tsunami
®
MP.11 family.
The MP 800 & 8000 devices that provide legacy support are,
•
MP-8100-SUA
•
MP-8150-SUR
•
MP-8150-SUR-100
•
MP-8200-SUA
•
MP-8250-SUR
•
MP-820-SUA-50
+
•
MP-820-SUA-100
•
MP-822-SUA-100
•
MP-825-SUR-50
+
•
MP-825-SUR-100
•
MP-825-CPE-50
•
MP-825-CPE-100
•
MP-835-CPE-10
•
MP-835-CPE-25
•
MP-835-CPE-50
•
MP-835-CPE-100
: MP 800/8000 BSU device in legacy mode can connect to a MP 800/8000 SU device only
when configured in legacy mode.
Parameter
Descriptions