Proxim Wireless Corporation XB92WFR ユーザーズマニュアル
Advanced Configuration
Tsunami
®
800 & 8000 Series - Software Management Guide
122
5.4.4 BSU / SU Profiles
In the BSU / SU Profiles tab, you can explicitly map a link profile to the peer device (See
). When a link is
established, using the peer MAC address, it is associated with a link profile based on the mapping created here. When no
explicit mapping is created then the link is associated with the default profile.
explicit mapping is created then the link is associated with the default profile.
5.4.4.1 Add a Profile
: In this section, we have explained the method to map a link profile to an SU. The same method should be followed to
map a link profile to a BSU.
To map a link profile to an SU device, navigate to ADVANCED CONFIGURATION > Wireless > Interface 1 > SU Profiles.
The SU Profiles screen appears:
The SU Profiles screen appears:
Announce Period
When roaming is enabled on a BSU, the BSU sends ANNOUNCE messages for every
configured Announce period. The Announce period can be configured in the range 25 to 100
milliseconds. By default, it is configured to 25 milliseconds.
configured Announce period. The Announce period can be configured in the range 25 to 100
milliseconds. By default, it is configured to 25 milliseconds.
When roaming is disabled on a BSU, the Announce period is set to 150 milliseconds.
: Reducing the Announce Period improves the roaming time and may result in lower
throughput.
Max. Packets Per Burst
When roaming is enabled on a BSU, the maximum number of messages that can be sent in a
burst can be configured in the range 1 to 16.
burst can be configured in the range 1 to 16.
When roaming is disabled on a BSU, the maximum packets per burst is set to 4.
:
•
Reducing the number of messages per burst improves the roaming time and may
result in lower throughput.
result in lower throughput.
•
If the maximum packets per burst configured in QoS (See Adding a New Service
Flow (SFC)) is greater than this value, then this parameter supersedes.
Flow (SFC)) is greater than this value, then this parameter supersedes.
Roaming VLAN ID
This parameter enables the user to configure the VLAN ID for Roaming management frames.
By default, the Roaming VLAN ID is set to -1 which indicates no tag is added to the Roaming
management frame. To set VLAN tag to the Roaming management frame, enter a value
ranging from 1 to 4094.
By default, the Roaming VLAN ID is set to -1 which indicates no tag is added to the Roaming
management frame. To set VLAN tag to the Roaming management frame, enter a value
ranging from 1 to 4094.
After configuring the above parameters, click OK and then COMMIT.
Parameter
Description