Proxim Wireless Corporation XB92WFR ユーザーズマニュアル
Monitor
Tsunami
®
800 & 8000 Series - Software Management Guide
255
7.11.5.1 Basic Mode
This mode helps to collect SNR and packet statistics report. The parameters under the Basic tab are described and tabulated
below:
below:
After configuring the Scan iteration value, click OK. Next, click Start, to scan. The scanned results are displayed in the form of
a graph as follows:
a graph as follows:
:
•
The frequencies are scanned by 5MHz slice starting from the lower edge of the frequency filter, and displays
the results captured at that particular instance.
the results captured at that particular instance.
•
When working in a high interference network, ensure to run the spectrum analyzer with multiple iterations
(increase the Scan Time) to get accurate results.
(increase the Scan Time) to get accurate results.
Figure 7-46 An Example - Scanned Results (Basic Mode)
Parameter
Description
Approximate Scan Duration
This parameter displays the total time (dd:hh:mm:ss) required to complete the scan.
Last Scanned Time
This parameter displays the time at which the last spectrum scan was done.
Scan Iterations
This parameter specifies the number of times the scan iterates. By default, the scan
iteration is set to 1. The configurable value can range from 1 - 1000.
iteration is set to 1. The configurable value can range from 1 - 1000.
:
• When the Spectrum Analyzer starts, the wireless link, if established, is terminated and re-established
after the scan is completed.
• As the wireless link is down during spectrum analysis, the remote device cannot be accessed. Hence, if
Spectrum Analyzer is started on a remote device, the results will not be available until spectrum scan is
completed and wireless link gets re-established.
completed and wireless link gets re-established.