Proxim Wireless Corporation XB92WFR ユーザーズマニュアル
Tsunami
®
800 & 8000 Series - Software Management Guide
314
G
Bootloader CLI and ScanTool
Bootloader CLI
The Bootloader CLI is a minimal subset of the normal CLI that is used to perform initial configuration of the device. The
Bootloader CLI is available when the device embedded software is not running.
Bootloader CLI is available when the device embedded software is not running.
This interface is only accessible through the serial interface, if:
•
The device does not contain a software image
•
An existing image is corrupted
•
An automatic (default) download of image over TFTP has failed
The Bootloader CLI provides the ability to configure the initial setup parameters; and depending on this configuration, a
software file is downloaded to the device during startup.
software file is downloaded to the device during startup.
The Bootloader CLI supports the following commands:
•
factory_reset
: Restore the factory settings
•
help
: Print Online Help
•
reboot
: Reboot the device
•
set
: Set the parameters
•
show
: Show the parameters
The Bootloader CLI supports the following parameters (for viewing and modifying):
•
ipaddr
: IP Address
•
systemname
: System Name
•
gatewayip
: Gateway IP Address
•
serverip
: Server IP Address
•
ipaddrtype
: IP Address Type
•
netmask
: Net Mask
•
filename
: Image file name (including the file extension)
If the Bootloader fails to load the firmware from flash, it tries to get the firmware from the network. While trying to get
firmware from the network, the device should be powered on using Ethernet 1 interface of the device. The default
configuration of the Bootloader parameters are as follows:
firmware from the network, the device should be powered on using Ethernet 1 interface of the device. The default
configuration of the Bootloader parameters are as follows:
Parameter
Value
ipaddr
169.254.128.132
netmask
255.255.255.0
gatewayip
169.254.128.132
systemname
systemname
serverip
169.254.128.133
filename
imagename
ipaddrtype
dynamic