Proxim Wireless Corporation XB92WFR ユーザーズマニュアル
Advanced Configuration
Tsunami
®
800 & 8000 Series - Software Management Guide
61
5.2.1.3.1 DNS
To configure the IP parameters of the device when operating in Routing mode, navigate to ADVANCED CONFIGURATION >
Network > IP Configuration. The IP Configuration screen appears:
Network > IP Configuration. The IP Configuration screen appears:
Figure 5-10 DNS Configuration (Routing Mode)
After configuring the required parameters, click OK, COMMIT and then REBOOT.
5.2.2 Static Route Table
: Applicable only in routing mode.
The Static Route Table stores the route to various destinations in the network. When packets are to be routed, the routing
table is referred for the destination address.
table is referred for the destination address.
DNS Proxy
DNS Proxy
It is a read-only parameter, which is enabled by default.
When DNS Proxy is enabled along with the DHCP server, the device will serve its own
address as the Primary DNS address to the DHCP client on the Ethernet.
address as the Primary DNS address to the DHCP client on the Ethernet.
:
•
If the DNS request from the client is destined to the device’s interface address
then the device acts as a DNS Proxy.
then the device acts as a DNS Proxy.
•
DNS Proxy is mostly applicable in scenarios where PPPoE Client is enabled on a
device and obtains its IP addresses dynamically from the PPPoE Server; And at
the same time, the device acts as a DHCP Server for a client.
device and obtains its IP addresses dynamically from the PPPoE Server; And at
the same time, the device acts as a DHCP Server for a client.
Parameter
Description
Primary and
Secondary IP Address
Secondary IP Address
Represents the IP address of the Primary and Secondary DNS Server.
Primary and Secondary IP address can be configured manually. The DNS address obtained
from the PPPoE-ipcp is given preference over manually configured IP addresses.
from the PPPoE-ipcp is given preference over manually configured IP addresses.
Parameter
Description