Proxim Wireless Corporation XB92WFR ユーザーズマニュアル
Advanced Configuration
Tsunami
®
800 & 8000 Series - Software Management Guide
67
After configuring the required parameters, click OK and then COMMIT.
:
•
Authorization Type and Authorization Key are valid only for RIPV2 and both versions.
•
The maximum metric of a RIP network is 15 hops, that is, a maximum of 15 routers can be traversed between a source
and destination network before a network is considered unreachable.
and destination network before a network is considered unreachable.
•
By default, a RIP router will broadcast or multicast its complete routing table for every 30 seconds, regardless of
whether anything has changed.
whether anything has changed.
•
RIP supports the split horizon, poison reverse and triggered update mechanisms to prevent incorrect routing updates
being propagated.
being propagated.
•
When RIP is enabled with Simple Authentication, MP 82x/8000 SUs/BSUs will not exchange RIP packets with 5012 or
5054 SUs/BSUs.
5054 SUs/BSUs.
5.2.5 PPPoE End Point (SU Only)
Proxim’s SU devices support Point-to-Point Protocol over Ethernet (PPPoE) which is a network protocol for transmitting
PPP frames over Ethernet. This feature is commonly used by Internet Service Providers (ISPs) to establish a Digital Subscriber
Line (DSL) Internet service connection with clients.
PPP frames over Ethernet. This feature is commonly used by Internet Service Providers (ISPs) to establish a Digital Subscriber
Line (DSL) Internet service connection with clients.
The Proxim’s SU devices support PPPoE only when they are configured in Routing Mode with NAT enabled. Also, the BSU
should always operate in Bridge Mode.
should always operate in Bridge Mode.
Parameter
Description
Name
Displays the interface type as either Ethernet 1, Ethernet 2, or Wireless.
Status
Enables you to either enable or disable RIP for a particular network interface.
Authorization Type
Enables you to select the appropriate Authorization Type. This parameter is not applicable
if RIP v1 is selected as the Version number.
if RIP v1 is selected as the Version number.
Authorization Key
Enter the authorization key. This parameter is not applicable if RIP v1 is selected as the
Version number. It is not applicable when the Authorization Type is set to None.
Version number. It is not applicable when the Authorization Type is set to None.
Version Number
Select RIP Version number from the Version Number list. Available options are V1, V2
and both. The default is V2.
and both. The default is V2.
Direction
You can enable RIP for both receiving and transmitting the data. To enable RIP only for
Receiving, select Rx Only. To enable RIP for both receiving and transmitting, select Rx and
Tx.
Receiving, select Rx Only. To enable RIP for both receiving and transmitting, select Rx and
Tx.