Proxim Wireless Corporation XB92WFR ユーザーズマニュアル
Advanced Configuration
Tsunami
®
800 & 8000 Series - Software Management Guide
95
:
•
Modifying any of the WORP parameters result in temporary loss of connectivity between the transmitter and
receiver.
receiver.
•
MAC ACL Status and RADIUS MAC ACL Status parameters cannot be enabled simultaneously.
After configuring the required parameters, click OK and then COMMIT.
Click Refresh, to view updated/refreshed blacklisted channels.
5.4.3 Wireless Interface Properties
To configure the wireless interface properties, navigate to ADVANCED CONFIGURATION > Wireless > Interface 1 >
Properties.
Properties.
The Wireless Interface Properties screen is classified under the following categories: Basic, Sync, MIMO, Frequency Filter,
DFS, DCS, Manual Blacklist, and Roaming.The parameters displayed in the Wireless Interface Properties screen may
vary according to the device type.
DFS, DCS, Manual Blacklist, and Roaming.The parameters displayed in the Wireless Interface Properties screen may
vary according to the device type.
5.4.3.1 Basic
Under Basic tab, you can configure and view the following parameters.
Figure 5-33 Wireless Interface Properties (BSU)