ZyXEL Communications Corporation 5VZ-A2011 ユーザーズマニュアル
Chapter 26 Troubleshooting
CellPipe 7130 RG User’s Guide
290
1
Make sure you understand the normal behavior of the LED. See
Section 1.6 on
page 26
.
2
Check the hardware connections. See the Quick Start Guide.
3
Inspect your cables for damage. Contact the vendor to replace any damaged
cables.
cables.
4
Turn the CellPipe 7130 RG off and on.
5
If the problem continues, contact the vendor.
26.2 CellPipe 7130 RG Access and Login
Note: Refer to
Section 3.2 on page 83
for user level information. Each user level has
its own account information for logging into the CellPipe 7130 RG.
I forgot the IP address for the CellPipe 7130 RG.
1
The default IP address is http://192.168.1.1.
2
If you changed the IP address and have forgotten it, you might get the IP address
of the CellPipe 7130 RG by looking up the IP address of the default gateway for
your computer. To do this in most Windows computers, click Start > Run, enter
cmd, and then enter ipconfig. The IP address of the Default Gateway might be
the IP address of the CellPipe 7130 RG (it depends on the network), so enter this
IP address in your Internet browser.
of the CellPipe 7130 RG by looking up the IP address of the default gateway for
your computer. To do this in most Windows computers, click Start > Run, enter
cmd, and then enter ipconfig. The IP address of the Default Gateway might be
the IP address of the CellPipe 7130 RG (it depends on the network), so enter this
IP address in your Internet browser.
3
If this does not work, you have to reset the device to its factory defaults. See
Section 1.7 on page 28
.
I forgot the password.
1
The default admin password is telus and the default user password is admin.
Note: Refer to
Section 3.2 on page 83
for user level information. Each user level has
its own account information for logging into the CellPipe 7130 RG.
2
If this does not work, you have to reset the device to its factory defaults. See
Section 1.7 on page 28
.