ZyXEL Communications Corporation AG220 ユーザーズマニュアル

ZyXEL AG-220 User’s Guide

32

Chapter 2 Tutorial

Note: Only one profile can be activated and used at any given time.

Figure 17   ZyXEL Utility: Profile Activate

8 When you activate the new profile, the ZyXEL utility goes to the Link Info screen while 

it connects to the AP using your settings. When the wireless link is established, the 
ZyXEL utility icon in the system tray turns green and the Link Info screen displays 
details of the active connection. 

9 Make sure the selected AP in the active profile is on and connected to the Internet. Open 

your Internet browser, enter 

http://www.zyxel.com

 or the URL of any other web site in 

the address bar and press ENTER. If you are able to access the web site, your new profile 
is successfully configured. 

10If you cannot access the Internet, go back to the Profile screen. Select the profile you are 

using and click Edit. Check the details you entered previously. Also, refer to the 
Troubleshooting section of this User's Guide or contact your network administrator if 
necessary.

In access point mode, your AG-220 allows you to set up your wireless network without using 
a dedicated AP. Refer to 

 for more 

information.

Note: With WZC, you cannot use the AG-220 as an access point.

After you install the ZyXEL utility and then insert the AG-220, follow the steps below to set 
up your AG-220 as an AP. 

1 Select AP Mode in any utility screen and wait for five seconds. The screen changes and 

displays as shown next. Under Status, you can view the current settings on the AG-220. 
In the Association List, you can see if any wireless clients have connected to your AG-
220.