ZyXEL Communications Corporation P660HNT1AV2 ユーザーズマニュアル

 Chapter 7 Home Networking

P-660HN-Tx(A) v2 User’s Guide

• 192.168.0.0 — 192.168.255.255

You can obtain your IP address from the IANA, from an ISP or it can be assigned from a private 
network. If you belong to a small organization and your Internet access is through an ISP, the ISP 
can provide you with the Internet addresses for your local networks. On the other hand, if you are 
part of a much larger organization, you should consult your network administrator for the 
appropriate IP addresses.

Note: Regardless of your particular situation, do not create an arbitrary IP address; 

always follow the guidelines above. For more information on address assignment, 

please refer to RFC 1597, “Address Allocation for Private Internets” and RFC 1466, 

“Guidelines for Management of IP Address Space”.

RIP (Routing Information Protocol) allows a router to exchange routing information with other 
routers. The RIP Direction field controls the sending and receiving of RIP packets. When set to:

• Both - the ADSL Router will broadcast its routing table periodically and incorporate the RIP 

information that it receives.

• In Only - the ADSL Router will not send any RIP packets but will accept all RIP packets received.
• Out Only - the ADSL Router will send out RIP packets but will not accept any RIP packets 

received.

• None - the ADSL Router will not send any RIP packets and will ignore any RIP packets received.

The Version field controls the format and the broadcasting method of the RIP packets that the 
ADSL Router sends (it recognizes both formats when receiving). RIP-1 is universally supported; but 
RIP-2 carries more information. RIP-1 is probably adequate for most networks, unless you have an 
unusual network topology.

Both RIP-2B and RIP-2M sends the routing data in RIP-2 format; the difference being that RIP-2B 
uses subnet broadcasting while RIP-2M uses multicasting.   Multicasting can reduce the load on 
non-router machines since they generally do not listen to the RIP multicast address and so will not 
receive the RIP packets. However, if one router uses multicasting, then all routers on your network 
must use multicasting, also. 

Traditionally, IP packets are transmitted in one of either two ways - Unicast (1 sender - 1 recipient) 
or Broadcast (1 sender - everybody on the network). Multicast delivers IP packets to a group of 
hosts on the network - not everybody and not just 1. 

IGMP (Internet Group Multicast Protocol) is a network-layer protocol used to establish membership 
in a Multicast group - it is not used to carry user data. IGMP version 2 (RFC 2236) is an 
improvement over version 1 (RFC 1112) but IGMP version 1 is still in wide use. IGMP version 3 
supports source filtering, reporting or ignoring traffic from specific source address to a particular 
host on the network. If you would like to read more detailed information about interoperability 
between IGMP version 2 and version 1, please see sections 4 and 5 of RFC 2236. The class D IP 
address is used to identify host groups and can be in the range 224.0.0.0 to 239.255.255.255. The 
address 224.0.0.0 is not assigned to any group and is used by IP multicast computers. The address 
224.0.0.1 is used for query messages and is assigned to the permanent group of all IP hosts