NantWorks 1001008 ユーザーズマニュアル
This page contains copyrighted materials that are “Confidential” and/or “Proprietary” and, as such, shall not be copied, distributed, or reproduced
in any way without the written consent of NantHealth’s Vice President of Quality and Regulatory Affairs.
in any way without the written consent of NantHealth’s Vice President of Quality and Regulatory Affairs.
HBH-v01.00.00-0-LP-User_Manual-R01
Page 10 of 17
Note: Do not attempt to remove or replace the HBox internal battery. The lithium-ion battery in HBox should be serviced only by NantHealth, and
must be recycled or disposed of separately from household waste.
must be recycled or disposed of separately from household waste.
Safe Shutdown
•
HBox remains operational without interruption when power is discontinued and then returned in less than 10 seconds
•
HBox completes a safe shutdown if power is discontinued for more than 10 seconds
•
If power is returned while HBox is shutting down, HBox will immediately reboot once the shutdown process completes
Master Reset Button
The master reset button is for the purpose of rebooting the HBox in the event it becomes unresponsive due to a software or a firmware crash. The
button is located underneath the plastic door on the side of HBox. It is accessible only by paperclip or pin.
button is located underneath the plastic door on the side of HBox. It is accessible only by paperclip or pin.
•
HBox will immediately power down when master reset button is pressed
•
HBox will begin normal startup when master reset button is released
Chapter 7: HBox Mounting Options
Universal Mount
HBox has a wall mount which allows it to be mounted to any flat surface such as a wall, table stand, or medical equipment carts.
•
The universal mount is compatible with a hole pattern that consists of two horizontal holes that range from 1 ¼ inches to 2 ¾ inches
apart
apart
•
The maximum screw diameter is 3.2mm
Note: Even if not mounted to a wall, HBox should always be used with the back mounting bracket so that unintentional disconnection of the
Ethernet cable will not occur.
Ethernet cable will not occur.