Motorola Mobility LLC T56CQ1 ユーザーズマニュアル
APPLICANT: MOTOROLA, INC.
FCC ID: IHDT56CQ1
Exhibit 8A
Revised 1-22-03
OEM integrators and end-users will be provided with the following instructions to satisfy
rf exposure requirements.
rf exposure requirements.
Included in end-users operating manual:
User Operation
Do not operate your telephone when a person is within 8 inches (20 centimeters) of the
antenna. A person or object within 8 inches (20 centimeters) of the antenna could impair
call quality and may cause the phone to operate at a higher power level than necessary
and expose that person to RF energy in excess of that established by the FCC RF
Exposure Guidelines.
Do not operate your telephone when a person is within 8 inches (20 centimeters) of the
antenna. A person or object within 8 inches (20 centimeters) of the antenna could impair
call quality and may cause the phone to operate at a higher power level than necessary
and expose that person to RF energy in excess of that established by the FCC RF
Exposure Guidelines.
IMPORTANT
The telephone must be installed in a manner that provides a minimum separation
distance of 20 cm or more between the antenna and persons to satisfy FCC RF
exposure requirements for mobile transmitting devices.
distance of 20 cm or more between the antenna and persons to satisfy FCC RF
exposure requirements for mobile transmitting devices.
Included in instructions to equipment installer:
Antenna Installation
IMPORTANT:
To comply with the FCC RF exposure limits and satisfy the categorical exclusion
requirements for mobile transmitters, the following requirements must be met:
requirements for mobile transmitters, the following requirements must be met:
1. The approved tri-mode antenna is installed on the roof, and a minimum
separation distance of 20 cm must be maintained between the antenna and all
persons.
2. The transmitter effective radiated power must be less than:
separation distance of 20 cm must be maintained between the antenna and all
persons.
2. The transmitter effective radiated power must be less than:
§ 800 MHz Band:
1.5 Watts ERP (2.45 Watts or 33.9 dBm EIRP)
§ 1900 MHz (PCS) Band:
3.0 Watts ERP (4.9 Watts or 36.9 dBm EIRP).
Based on the power output of the mobile phone transmitter, this requires that the
combination of antenna gain and feed line loss does not exceed:
combination of antenna gain and feed line loss does not exceed:
§ 800 MHz Band:
-0.9 dB (loss)
§ 1900 MHz (PCS) Band:
12.6 dB (gain)
The approved tri-mode antenna and cable configurations meet these requirements.