Hunter Fan Company TX14 ユーザーズマニュアル

20

41462-01   04/06/01

®

IMPORTANT: Before using this con-
trol, change the factory default DIP
switch settings on the Remote and
the Fan, to your own unique code.
Refer to Figure 9a, 9b and 9c.

Dip Switch

Motor Cover

Note: All fans leave the factory set to
‘01110’.

Note: If this is the second fan in-
stalled in the same area, one of the
fans MUST have its channel changed
from ‘01110’ or interference will oc-
cur.  Make sure that the dip switch
settings in both the second remote
and second fan are set to the same
different numbers.

1. Remove the three motor cover

screws and lift the motor cover
off.

2. Through the view hole on top of

the motor, locate the dip switch.
Refer to Figure 9a.

3. Check that the dip switch in the

fan and the remote are set to the
same unique numbers.

4. Replace the cover and screws.

By changing the sliding switches on
the fan and remote DIP switches,
many combinations of unique num-
bers can be selected.  Refer to Fig-
ure 9b. On = 0 and off = 1.

DIP Switch

Set to
01110

DIP Switch

Set to
01001