Audiotel International Limited 2-400-0001 ユーザーズマニュアル
4
AUDIOTEL INTERNATIONAL MN400872 Issue 1 (08/04)
D
ETECT
IV User Manual
AUDIOTEL INTERNATIONAL MN400872 Issue 1 (08/04)
5
Warnings
When operating the equipment within Europe where Type Approval is a legal requirement, all
equipment, including transmitter, receivers, microphones, batteries and aerials must be to type
approved standard in order for the system to remain type approved. Therefore, only equipment
supplied by Audiotel International should be used.
equipment, including transmitter, receivers, microphones, batteries and aerials must be to type
approved standard in order for the system to remain type approved. Therefore, only equipment
supplied by Audiotel International should be used.
It is the operator's responsibility to operate the equipment only on frequencies licensed to them.
FCC
NOTE This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not in-stalled and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not in-stalled and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
CE
MARK
EMC
COMPLIANCE
AND
R
ADIO
T
YPE
A
PPROVAL
The CE mark is affixed to the
D
ETECT
IV to confirm
compliance with the following European Community
Directives:
Directives:
Council Directive 89/336/EEC on the approximation of
Laws of Member States relating to Electromagnetic
Compatibility and the following EMC and Radio Type
Approval standards:
Laws of Member States relating to Electromagnetic
Compatibility and the following EMC and Radio Type
Approval standards:
EN 300 220-1
EN 300 440-1
EN 301 489-3
EN 300 330-1
EN 60950 LVD