National Datacomm Corporation 0630S02 ユーザーズマニュアル
InstantWave High Speed PCI/PC Card
11
step13. If the TCP/IP protocols are required (necessary for Internet access), add
them by clicking Start/Control Panel/Network/Configuration
That completes the hardware and driver installation.
Uninstalling the Adapter from Windows 95
You may need to uninstall your adapter for the following reasons:
1.
The installation fails or is interrupted by unknown factors. If this happens the
InstantWave Adapter will be marked with an exclamation mark “!” in Device
Manager. Uninstall the adapter using methods described below and then
restart your computer. The Windows 95 plug and play function will detect
the adapter again
InstantWave Adapter will be marked with an exclamation mark “!” in Device
Manager. Uninstall the adapter using methods described below and then
restart your computer. The Windows 95 plug and play function will detect
the adapter again
2.
You want to remove the device
The uninstallation process is as follows:
To completely remove the adapter and driver from your system you will need to
physically remove the adapter (with the system powered off). The removal
procedure is the reverse of the Hardware Installation procedure on page 6. Restart
the computer and then proceed as follows:
procedure is the reverse of the Hardware Installation procedure on page 6. Restart
the computer and then proceed as follows:
step1. In Control Panel click the Network icon
step2. Highlight the InstantWave adapter driver entry
step3. Click the Remove button to remove the old InstantWave adapter driver
step4. Click OK. The system will ask you to restart the PC. Click Yes