National Datacomm Corporation 0630S02 ユーザーズマニュアル

14   

computer’s BIOS on the PnP and PCI Settings page, “PnP OS
Installed” is set to NO.

step1.    Double-click My Computer, double-click Control Panel

step2.    Double-click the Network icon to open the Network  window.  Select the

Adapters card

step3.    Click Add.  The Select Network Adapter dialog box will open

step4.    Click Have Disk

step5.    Insert the Windows NT driver diskette into drive a (or b) and then type

a:\winnt (or b:\winnt)

step6.    Click OK.  The Select OEM Option dialog box will open.

step7.    Select the correct adapter and click OK.  If PC Card  is selected, the

dialog box for setting the Interrupt number and I/O address will be
shown.  Users can specify a different Interrupt number and I/O address
for this adapter if there is a conflict with an existing card in the
computer

step8.    Click OK.  The InstantWave PCI Adapter Setup dialog box will open.

Select the Network Type and Carrier Set.  If the station is connected to
an Access Point, Infrastructure mode must be specified.  Select Ad Hoc
mode to make a peer to peer connection to other wireless stations.  If
the country of operation is different from the country in which the
product was purchased, the user can change the carrier set.  All wireless
stations and Access Points must use the same Carrier Set in order to
communicate.  The Domain name should be the same as the network
domain to which the station will be connected

step9.    Click OK.  The Roaming dialog box will open.

step10.    When Roaming is enabled, the station is allowed to roam to another

Access Point under the same Domain Name whenever the radio signal
quality of the currently connected AP is below an acceptable level.
Click OK.  The Security dialog box will appear.