National Datacomm Corporation 0650S02 ユーザーズマニュアル

6  InstantWave  High Speed 

This section explains some of the things you need to consider in planning an
Infrastructure network.  Setting up is a two step process.

1.  Install and configure the InstantWave High Speed products
2.  Decide the best physical location of the InstantWave High Speed products so

as to optimize performance

The following sections give quick guidelines for these two steps.  Before we go
into detail, the network planner should first decide whether to have a single AP
wireless network or a multiple AP network

If you are setting up a simple network with only one AP and a few Stations (a Type
1 or Type 2 network configuration as described in Infrastructure Network, page  4),
the installation can be performed painlessly.  All you need to do is make sure the
AP and all the wireless Stations hold the same 
configuration.

Adding a new Station to an existing Infrastructure Network is easy.  Again, all you
need to do is to set the newly added Station

 to be the same as

Install multiple APs in the same network (or Domain) with an overlapping signal
(Figure 3

•

 

Use the same Domain Name

•

 

The roaming function in the Station if roaming is desired.