National Datacomm Corporation 0650S02 ユーザーズマニュアル

ページ / 52
 InstantWave  
High Speed
 
Access Point For Small Business
  9
Getting Started
Access Point Hardware Installation
Access Point Hardware Setup explains how to quickly setup the Access Point for
use via a wired Ethernet connection, and using the factory default settings.  For
installation in networks using other than the default settings, i.e. into existing
networks, complete the Hardware Setup and refer to AP COMFig Tool, page 12.
To setup a wireless station, refer to the PCI/PC Card User
Figure 4.   Access Point
Step1  .  Placing the antenna in a higher location may result in better signal
transmission/reception to/from the wireless stations (see Placing For
Performance, page 8
)
Figure 5.   Access Point
Step2  .  Connect the Ethernet network cable to either the UTP port (see 
Figure
5
).  If both types of cables are connected at the same time, the AP will
only utilize the UTP connection first
Step3  .  Connect the power adapter to the electricity outlet and then to the
Access Point DC-In port (see 
Figure 5 
)
Step4  .  Turn on the AP power switch
The Access Point is now ready to communicate with the wireless stations using its
factory default settings.  Refer to the InstantWave High Speed PCI/PC Card User
Guide for card setup instructions.
Rear