National Datacomm Corporation 0650S02 ユーザーズマニュアル
20 InstantWave High Speed
Access Point For Small Business
Read
Read-only rights. The user may read everything
except the Access Control settings, but cannot
alter anything
except the Access Control settings, but cannot
alter anything
Read/Write
The user may read and alter all settings
When all the settings are made, click OK to return to the Access Control card. On
the Access Control card, click the Apply button to make the changes effective
immediately, without closing the dialog box, or click OK to accept the changes and
close the box. Clicking Add to APMS Host Table will add the information to the
host table referred to by the APMS program.
the Access Control card, click the Apply button to make the changes effective
immediately, without closing the dialog box, or click OK to accept the changes and
close the box. Clicking Add to APMS Host Table will add the information to the
host table referred to by the APMS program.
Perform AP Self Diagnostic Test
On the Service card, click Perform AP Self Diagnostic Test. The Hardware
Diagnosis screen will open (Figure 15)
Diagnosis screen will open (Figure 15)
Figure 15. Hardware Diagnosis
Click Start and the tests will commence. As each item is tested a yellow arrow
will appear alongside it. If the test is successful, the arrow will change to a green
tick. You can click Cancel at any time to stop the tests. Whenever a failure has
occurred, an “X” will appear alongside it. When the tests have completed, the
Cancel button changes to a Close button. Click Close to return to the Service card.
will appear alongside it. If the test is successful, the arrow will change to a green
tick. You can click Cancel at any time to stop the tests. Whenever a failure has
occurred, an “X” will appear alongside it. When the tests have completed, the
Cancel button changes to a Close button. Click Close to return to the Service card.
Update AP Firmware
The Access Point’s (AP’s) embedded software is burned into the flash ROM.
However, an updated AP code may be installed via a COM port using the AP
COMFig program. Click on Update AP Firmware (
However, an updated AP code may be installed via a COM port using the AP
COMFig program. Click on Update AP Firmware (
Figure 8
). The Update AP
Firmware dialog box will open
.
Use the Browse button to choose the file to be uploaded to the AP, or type the file
location and name in the File Name field.
location and name in the File Name field.
The Update button will then become enabled. Click Update to start loading the
file to the Access Point. The AP COMFig tool will upload the new executable into
the AP’s flash memory area.
file to the Access Point. The AP COMFig tool will upload the new executable into
the AP’s flash memory area.
When the file transfer is complete, click Close to close the window.