National Datacomm Corporation 0650S02 ユーザーズマニュアル
InstantWave
High Speed
Access Point For Small Business
31
Note: Do not set all the stations in the Access Control table to Read-only. Once
this is set and enabled, it will be difficult to modify the AP. Should this
situation occur, refer to Troubleshooting , page 37
situation occur, refer to Troubleshooting , page 37
Two levels of access are available. To set access rights, enter a station
and community string (the community string must be the same as the AP
Host Table of the APMS manager terminal <i.e.the PC running APMS>), see
Create New AP, page 27and choose Read or Read/Write.
and community string (the community string must be the same as the AP
Host Table of the APMS manager terminal <i.e.the PC running APMS>), see
Create New AP, page 27and choose Read or Read/Write.
Read
Read-only rights. The user may read everything
except the Access Control settings, but cannot
alter anything
except the Access Control settings, but cannot
alter anything
Read/Write
The user may read and alter all settings
The Add button will become active. Click Add to add the information to the AP
Access Control table. Click another tab to continue configuration setting or click
OK to complete the AP setting. Click the Config/Reset AP menu item to make the
changes effective.
Access Control table. Click another tab to continue configuration setting or click
OK to complete the AP setting. Click the Config/Reset AP menu item to make the
changes effective.
Wireless:
Clicking on the Wireless tab opens the Wireless card. The Wireless card groups all
the user configurable wireless Access Point (AP) functions. Here you may:
the user configurable wireless Access Point (AP) functions. Here you may: