Davis Instruments DWW6357 ユーザーズマニュアル
Troubleshooting
15
2. Let the “pointed” side of the module drop away from the ISS base, and slide the
module down and away from the base, as shown above.
3. Use a damp, soft cloth to gently remove any debris from the Tipping Spoon mod-
ule, being careful not to damage any moving parts or scratch the spoon.
4. When all parts are clean, rinse with clear water, and replace the module into the
bottom of the ISS base as follows:
a) Tilting the module at a slight angle relative to the ISS base, insert the two tabs on
the “flat” side of the module (under the tipping magnet, as noted in the figure
below) into the “flat” side of the opening of the ISS base.
the “flat” side of the module (under the tipping magnet, as noted in the figure
below) into the “flat” side of the opening of the ISS base.
b) Rotate the “pointed” side of the module up to the base, and tighten the Phillips
head screw.
head screw.
Troubleshooting
Troubleshooting ISS Reception
If the console isn’t displaying data from the ISS, perform the following steps:
1. Verify that the console is powered and is not in Setup Mode.
2. Make sure that the ISS battery is properly installed.
3. Walk around the room with the console, standing for a few moments in various
1. Verify that the console is powered and is not in Setup Mode.
2. Make sure that the ISS battery is properly installed.
3. Walk around the room with the console, standing for a few moments in various
locations, to see if you are picking up signals from the ISS. Look on the screen’s
lower left quadrant for the small graphic of a radio antenna. Small “radio wave
semi-circles” display above the antenna and toggle on and off when the console
receives a transmission.
lower left quadrant for the small graphic of a radio antenna. Small “radio wave
semi-circles” display above the antenna and toggle on and off when the console
receives a transmission.
If you do not see the antenna’s radio wave graphic slowly blinking, regardless of
where you stand with the console, you should call the Davis Technical Support
Department. See “Contacting Davis Instruments” on page 17 for more informa-
tion.
where you stand with the console, you should call the Davis Technical Support
Department. See “Contacting Davis Instruments” on page 17 for more informa-
tion.
4. If the Transmitter ID LED remains unlit, there is a problem with the ISS transmit-
Replacing the Tipping Spoon module in the ISS base.
Insert the Phillips
head screw here.
When replacing this
module, first slide these
tabs into the ISS base,
then insert the Phillips
head screw.
module, first slide these
tabs into the ISS base,
then insert the Phillips
head screw.