MilDef Crete Inc. RT886EX ユーザーズマニュアル

ページ / 66
Components and Functions 
17
DVD-ROM Drive 
The DVD-ROM drive is a standard IDE ATAPI type, which accepts 
a variety of standard 12cm CDs such as CD-ROM, audio CD, CD-I, 
Photo CD, video CD, etc. 
The following procedure assumes that all the necessary DVD-ROM 
utilities were installed on the computer. For DVD-ROM utility 
installation, please refer “Utilities and Drivers”.
DVD-ROM drive also can be removed and swapped with 2
nd
 battery. 
Put CD into DVD-ROM drive 
While the power is ON, push the DVD-ROM drive’s ejecting button.  
The tray will release. Then gently pull the tray out. Put the CD on the 
holder and push the tray back into the cabinet. Any dirt on the data 
side of the CD may cause read error. Please do not touch this side 
when handling CDs. 
Read from DVD-ROM drive 
The DVD-ROM drive may be designated as drive D: or higher 
depending on your configuration. You may access it in DOS or 
Windows the same way you would for the floppy disk drive or hard 
disk drive. The DVD-ROM is a read-only device. Any command 
attempting to write onto it will be denied. 
Please avoid shock or vibration while the DVD-ROM drive is active. 
Express and PCMCIA Cards 
The computer supports one type-II PCMCIA and one Express card or 
two type-II PCMCIA cards. To remove the card, push the button on 
the right of the card to eject it. The eject button can hide into the 
compartment by pushing it inward gently.