Hobbico Inc 2CH900-49 ユーザーズマニュアル
R/C MicroCycles are recommended for ages 8 and older. To ensure the safety and fun of young modelers,
please follow these operating instructions and general safety rules:
please follow these operating instructions and general safety rules:
•
Adult supervision is recommended.
•
Do not allow children under age 3 to play with the
R/C MicroCycles or radio transmitter. Small parts
could be swallowed and cause suffocation.
R/C MicroCycles or radio transmitter. Small parts
could be swallowed and cause suffocation.
•
Do not pick up your R/C MicroCycles when it is in
motion. Keep hair, loose clothing, face and fingers
away from the tires and wheels.
motion. Keep hair, loose clothing, face and fingers
away from the tires and wheels.
•
R/C MicroCycles are for indoor use only, and may
be permanently damaged by outdoor dirt and dust.
be permanently damaged by outdoor dirt and dust.
•
Do not run your R/C MicroCycles on rugs or
carpeting. The fibers may become tangled in and
damage the model.
carpeting. The fibers may become tangled in and
damage the model.
•
Never charge, run, or store your R/C MicroCycles
in areas of high temperatures, low temperatures,
or high humidity. Do not store in direct sunlight.
in areas of high temperatures, low temperatures,
or high humidity. Do not store in direct sunlight.
•
Never operate your model in any area with
full-size vehicles.
full-size vehicles.
•
Moisture can cause electronic malfunction and
short circuits with strong electrical current. Should
your model become wet, stop using it immediately.
short circuits with strong electrical current. Should
your model become wet, stop using it immediately.
•
Never disassemble or solder the model.
Do not put it into fire.
Do not put it into fire.
•
Do not drop your model from
high places.
high places.
This device complies with Part 15 of the FCC rules. Operation is
subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this
device must accept interference received, including interference
that may cause undesired operation. The manufacturer is not
responsible for any radio or TV interference caused by
unauthorized modifications to this equipment. Such modifications
could void the user’s authority to operate the equipment.
subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this
device must accept interference received, including interference
that may cause undesired operation. The manufacturer is not
responsible for any radio or TV interference caused by
unauthorized modifications to this equipment. Such modifications
could void the user’s authority to operate the equipment.
Meets Canada 210 requirements.
Motorcycle Battery Care
Transmitter Battery Care
Always use “AA” alkaline batteries. If improper batteries
are used in the transmitter, they may become hot, leak,
and rupture. Follow these precautions:
are used in the transmitter, they may become hot, leak,
and rupture. Follow these precautions:
Four “AA” alkaline batteries are required. Never
use other types of batteries.
use other types of batteries.
1.
Remove the battery cover screw with a Phillips
screwdriver.
screwdriver.
2.
Install your batteries with the correct polarity.
3.
Replace the battery cover and tighten the screw.
A rechargeable battery is built into the main body
of the motorcycle. Using the battery incorrectly
will cause it to leak, rupture, or ignite. Follow
these precautions:
of the motorcycle. Using the battery incorrectly
will cause it to leak, rupture, or ignite. Follow
these precautions:
•
If your R/C MicroCycle has been unused for a
long period or you are charging its built-in battery
for the first time, the battery may not charge to
full capacity. This does not indicate battery
failure. Recharging and running the model 4 or 5
times will gradually lengthen run times.
long period or you are charging its built-in battery
for the first time, the battery may not charge to
full capacity. This does not indicate battery
failure. Recharging and running the model 4 or 5
times will gradually lengthen run times.
•
Fully discharge the battery by running the
motorcycle before recharging.
motorcycle before recharging.
•
Charge the battery only when the motorcycle is
NOT running. To prevent overcharging, never
recharge a battery which has already been fully
charged. This will not increase running speed.
NOT running. To prevent overcharging, never
recharge a battery which has already been fully
charged. This will not increase running speed.
•
Recharge the battery only with the transmitter’s
built-in charger.
built-in charger.
•
If the chassis becomes warm, let it cool before
running again.
running again.
•
Never use rechargeable batteries, such as NiCds,
in the transmitter.
in the transmitter.
•
Do not mix different types of batteries, or old and
new batteries.
new batteries.
•
When changing batteries, replace ALL of the old
batteries with new ones.
•
Make sure the batteries are installed with the
correct polarity as shown in the battery
compartment.
correct polarity as shown in the battery
compartment.
•
Do not charge or disassemble your transmitter
batteries. Never allow them to become hot or to
burn. To avoid short-circuits, avoid getting them wet.
batteries. Never allow them to become hot or to
burn. To avoid short-circuits, avoid getting them wet.
•
If liquid from inside the batteries contacts your skin
or clothes, wash them with water. If leaked battery
fluid gets into your eyes, flush them immediately
with cool water and seek medical attention. Do
not rub eyes.
or clothes, wash them with water. If leaked battery
fluid gets into your eyes, flush them immediately
with cool water and seek medical attention. Do
not rub eyes.
•
You can race about 50 times with new “AA”
alkaline batteries.
Transmitter Battery Installation
This product uses a recyclable NiCd battery. To
dispose of the battery, remove it and take it to a
recycling center.
dispose of the battery, remove it and take it to a
recycling center.
Entire Contents © Copyright 2004 – 3033140 Printed in China
TM
How to Charge
How to Race
Troubleshooting
GENERAL SAFETY PRECAUTIONS
BATTERY HANDLING AND CARE
Position the motorcycle with the front-end facing the same direction
as the antenna on the transmitter.
as the antenna on the transmitter.
Snap your model onto the built-in charger.
The metal contacts on the motorcycle and the charger must make
contact. While charging, keep pressing the motorcycle against the
transmitter and make sure the CHARGE light is on.
contact. While charging, keep pressing the motorcycle against the
transmitter and make sure the CHARGE light is on.
The charge light on the front of the transmitter will light for 45
seconds. When it goes out, the battery has completed charging.
seconds. When it goes out, the battery has completed charging.
Gently pull up the antenna on the transmitter.
Turn on the MicroCycle at the rear of the motorcycle.
Place on hard, smooth surface and be prepared for fast action!
Steer the front tire left or right by pushing the directional toggle control.
2
3
4
1
2
3
4
1
2
1
☞
To race, each car must be on a different frequency
.
off
on
2
4
O
N
/O
FF
S
WITCH
Turn the MicroCycle off at the rear of the motorcycle.
Gently push the antenna back into the transmitter.
After Racing
®
Motorcycle does
not run
not run
Probable Cause: Transmitter
battery capacity is low, or
batteries have not been installed.
battery capacity is low, or
batteries have not been installed.
Probable Cause: Radio
signals don’t seem to reach
the motorcycle.
signals don’t seem to reach
the motorcycle.
Correction: Install four brand-
new “AA” alkaline batteries (they
must be alkaline).
new “AA” alkaline batteries (they
must be alkaline).
Correction: Fully extend the
antenna on the motorcycle and
transmitter. Maximum range is
10-15 feet.
antenna on the motorcycle and
transmitter. Maximum range is
10-15 feet.
Motorcycle does not
operate properly
operate properly
Probable Cause: Are you
driving your motorcycle on a rug?
driving your motorcycle on a rug?
Probable Cause: Is there dust
and/or lint on the tires?
and/or lint on the tires?
Correction: R/C MicroCycles
are not intended for running on
rugs or carpets.
are not intended for running on
rugs or carpets.
Correction: Remove dust/lint
from the tires.
from the tires.
Motorcycle moves
uncontrollably
uncontrollably
Probable Cause: Interference
from reflected radio waves
from reflected radio waves
Probable Cause: Are you
running with another motorcycle
on the same frequency?
running with another motorcycle
on the same frequency?
Correction: Turn off electronic
devices or move to a different
location.
devices or move to a different
location.
Correction: Each motorcycle
must be on a different frequency.
must be on a different frequency.
R/C MicroSizers
MicroCycles
MicroCycles
HCAC0991-0996
Tested To Comply
With FCC Standards
With FCC Standards
FOR HOME OR OFFICE USE