Echelon Corporation 70101-R003 ユーザーズマニュアル
ECN 7000 Series Hardware Guide
23
installation. After a card is installed, you must screw the card retainer back in
place to prevent the card from becoming dislodged during transportation.
If the expansion card requires electrical connections to external devices, those
If the expansion card requires electrical connections to external devices, those
electrical connections must be positioned as close as possible to the edge of the
card facing the external connection plate. Connection between the card and the
IP66 connector on the ECN external connection panel must use a short cable.
Installation for Card Type C
Access to expansion slots 3 and 4 can be made while the card cage is installed in
the outer enclosure:
1. Remove the enclosure cover
2. Remove the inner card cage cover
3. Remove the individual RF shields
2. Remove the inner card cage cover
3. Remove the individual RF shields
Card guides are made available for each slot, which (along with the alignment
holes in the ECN main board) prevent expansion cards from being misaligned on
installation. After a card is installed, you must reinstall the RF shielding.
Make antenna connections using a suitable coaxial cable, and exit the shielding
Make antenna connections using a suitable coaxial cable, and exit the shielding
as recommended. Routing for antenna cables must follow the requirements
described in your compliance approvals. The antennas must be installed as
directed using the mounting points provided.
Installation for Card Type D
Access to expansion slot 5 can be made while the card cage is installed in the
outer enclosure:
1. Remove the enclosure cover
2. Remove the inner card cage cover
3. Remove the RF shield that protects the slot
2. Remove the inner card cage cover
3. Remove the RF shield that protects the slot
Mount the card to the four PCB standoffs located inside the shielded enclosure
using four retaining screws. You must provide an interface for the card that is
compatible with expansion slot 5’s mechanical and electrical requirements. You
can install multiple cards at this location.
Make antenna connections using a suitable coaxial cable, and exit the shielding
Make antenna connections using a suitable coaxial cable, and exit the shielding
as recommended. Routing for antenna cables must follow the requirements
described in your compliance approvals. The antennas must be installed as
directed using the mounting points provided.
Installation for Card Type E
Access to expansion slot 6 can only be made when the inner card cage is removed
from the outer enclosure. Gain access to the slot by removing the slot cover plate.
Mount the card using five PCB standoffs that you screw to the cover plate.
Mount the card using five PCB standoffs that you screw to the cover plate.
Reinstall the cover plate and card into the card cage as a single assembly. You
must provide an interface for the card that is compatible with expansion slot 6’s
mechanical and electrical requirements. You can install multiple cards at this
location.