Echelon Corporation 76510R ユーザーズマニュアル
Street Light Bridge Integrator’s Guide
121
the local drive of your computer, a USB drive, another removable media,
or a shared network drive with read/write permissions.
2. Restore the target SmartServer to its factory default settings with the
Setup – Cleanup Web page or the console application:
• To restore your SmartServer to its factory default settings using the
• To restore your SmartServer to its factory default settings using the
SmartServer Web pages, right-click the local SmartServer, point to
Setup, and select Clean Up from the shortcut menu. The Setup –
Cleanup dialog opens. Click Cleanup to reset the SmartServer.
Cleanup dialog opens. Click Cleanup to reset the SmartServer.
• To restore your SmartServer to its factory default settings using the
console application, enter the factorydefaults command, or enter the
factorydefaults keepipaddrs command to reset the SmartServer but
keep its basic IPv4 and IPv6 IP addresses. For more information
about using the SmartServer console application, see Appendix B of
about using the SmartServer console application, see Appendix B of
the
i.LON SmartServer User’s Guide
.
3. Copy the config/network/<
Network
>/<
Channel
>/<
i.LON SmartServer
App Device
> folder to the root/config/network/<
Network
>/<
Channel
>
folder on the flash disk of the target SmartServer.
4. Reboot the target SmartServer using the SmartServer Web pages or the
SmartServer console application:
• To reboot your SmartServer using the SmartServer Web pages,
• To reboot your SmartServer using the SmartServer Web pages,
right-click the local SmartServer, point to Setup, and select Reboot
from the shortcut menu. The Setup – Reboot dialog opens. Click
Reboot to start the reboot.
• To reboot your SmartServer using the SmartServer console
application, enter the reboot command. For more information about
using the SmartServer console application, see Appendix B of the
using the SmartServer console application, see Appendix B of the
i.LON SmartServer User’s Guide
.
5. You can open the Web interface of the target SmartServer and expand
the SmartServer’s App device in the navigation pane on the left side.
Observe that the functional blocks and data points in the SmartServer
App device match those of the source. You can click of the Scheduler
functional blocks under the SmartServer App device and observe that it
functional blocks under the SmartServer App device and observe that it
has the same configuration as the source.
6. Repeat steps 2–5 to copy the SmartServer App device configuration to
additional target SmartServers.