Knogo North America Inc T-2000 ユーザーズマニュアル

1

Caution

Changes or modifications not expressly approved by the party responsible for compliance
to the FCC rules could void the user’s authority to operate this equipment.

Pre-installation requirements:

1.  Pedestals must be mounted at least 2-3 feet away from all mechanical and electrical

devices or large metal objects to avoid spurious resonances and noise sources. This
includes doorframes, window frames, walls, beams, alarm wiring, etc.

1. All system wiring (including the AC power) must enter and exit the center of every

antenna base at a 90-degree angle (down the middle at a right angle to the antenna
base). If the wiring makes a turn before it enters or after it exits the base, the turn
must occur at least 1 foot away from the base.

2. All system wiring must never run vertically near the antenna. Wiring should run

underneath the floor or on top of the floor in electrical metallic tubing or metallic
floor molding. If the wiring must run vertically, make sure it is at least 3’ away from
the antenna.

3. AC power should be a 3-wire dedicated line.

Connect the 18VAC from the transformer to TB4 pin 1 and pin 3 on the RV.
Using the red/black 18ga. Twisted pair provided;
Connect the red wire from TB4 pin 1 on the RV to TB1 pin 1 on the TX.
Connect the black wire from TB 4 pin 3 on the RV to TB1 pin 3 on the TX.
All wiring should be run perpendicular to the antennae.

Installation:

1.  Mount the RV antenna and the TX antenna so that the aisle-width is 3 feet.

2.  Verify that the controls on the TX PCB are set as follows:

R45

Center Freq.

Pre-set at factory for 8.2MHz

R17

Sweep Width

Pre-set at factory

R36

Transmit Level

Pre-set at factory

JP1

Slave termination

HI-Z

JP6

MSTR

installed

JP7

FBR SLV

not installed

JP8

WRD SLV

not installed