Movea Inc DD2 ユーザーズマニュアル
Thomson/Gyration Confidential
Page 12 of 21
Programming the Remote
The RCU can be programmed to operate many brands of remote-controllable TVs via the
IR functions of the RCU.
IR functions of the RCU.
Find Out If You Need to Program the Remote
To determine whether the remote needs to be programmed to operate your TV, do the
following:
1. Turn on the TV.
2. Point the remote at the TV.
3. Press the TV button.
4. Press ON•OFF to see if the TV responds. If the TV doesn’t respond, you must program
the remote to operate it.
following:
1. Turn on the TV.
2. Point the remote at the TV.
3. Press the TV button.
4. Press ON•OFF to see if the TV responds. If the TV doesn’t respond, you must program
the remote to operate it.
Programming Methods
There are two ways to program the remote control to operate other TV’s: Automatic
Code Search and Direct Entry.
Code Search and Direct Entry.
Using Automatic Code Search [This function to be added later]
The following instructions can be used to program the remote to operate each of your
components. If you want to stop the automatic code search without programming any of
your components, press and hold CLEAR (*) until the indicator on the remote turns off.
components. If you want to stop the automatic code search without programming any of
your components, press and hold CLEAR (*) until the indicator on the remote turns off.
1. Turn on the component you want to operate (TV, DVD player, etc.)
2. Press and hold the component button you want to program (TV, AUX, etc.).
2. Press and hold the component button you want to program (TV, AUX, etc.).
While holding the component button, press and hold ON/OFF button until the
component button on the remote turns on, then release both buttons.
component button on the remote turns on, then release both buttons.
3. Point the remote at the component.
4. Press and release PLAY, then wait 5 seconds or until the component button stops
4. Press and release PLAY, then wait 5 seconds or until the component button stops
flashing. At this point the remote is searching for the correct code to program. If,
after 5 seconds, the component you want to operate does not turn off, press PLAY
again to tell the remote to search the next set of codes. Continue pressing and
releasing PLAY until the component turns off or you have searched through all of
the codes. The component buttons flash when all codes have been searched, the
component button turns off, and the RCU exits Automatic Code Search.
after 5 seconds, the component you want to operate does not turn off, press PLAY
again to tell the remote to search the next set of codes. Continue pressing and
releasing PLAY until the component turns off or you have searched through all of
the codes. The component buttons flash when all codes have been searched, the
component button turns off, and the RCU exits Automatic Code Search.
If the component you want to control does turn off:
1. Press and release REVERSE, then wait 2 seconds. Repeat this step until the
component turns back on.
2. To finish, press and hold STOP until the component button on the remote turns
off.