On Track Innovations Ltd OTI-GMS-V1 ユーザーズマニュアル
Antenna Controller User Manual Ver. 1.00
FCC Compliance
FCC Compliance
P/N 1100031
page a
FCC Compliance
Labeling Requirements CFR 47, FCC part 15, Sections 15, 19, 109.
A device shall bear the following label in a conspicuous location on the Antenna
Controller.
A device shall bear the following label in a conspicuous location on the Antenna
Controller.
OTi GMS
FCC ID: JNX-OTI-GMS-V1
Manufacturer: On Track Innovations Ltd.
This device complies with Part 15of the FCC Rules.
Operation is subject to the following two conditions:
This device complies with Part 15of the FCC Rules.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. this device must accept any interference received, including
interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
••••
Reorient or relocate the receiving antenna.
••••
Increase the separation between the equipment and receiver.
••••
Connect the equipment into an outlet on a circuit different from that to which
this receiver is connected.
••••
Consult the dealer or an experienced radio/TV technician for help
Changes or modifications in this equipment, not expressly approved by the party
responsible for compliance (On Track Innovations Ltd,) could void the user’s
authority to operate the equipment.
responsible for compliance (On Track Innovations Ltd,) could void the user’s
authority to operate the equipment.