On Track Innovations Ltd OTI-EFPRFN900A ユーザーズマニュアル

 

 

 3-1: Battery Installation 

The RFN unit is supplied with the battery connector disconnected. To connect the 
battery open the four cover screws, remove the RFN top cover and connect the battery 
connector to the RFN battery connector.  
After connection stuff the battery cable into the niche by the battery as shown in the 
figure 3-1 above, return the RFN top cover and close the four cover screws. 
Note: The male and the female parts of the two pin battery connectors are interlocked 
to avoid reverse connection. If mating is resisted - reverse direction and try again.  

Insert the RFN and its adaptor ring over the fuel nozzle spout and saddle it on the fuel 
nozzle base. Use 2mm Allen key to close the RFN locking screws and lock the RFN 
firmly in place. 

For proper field operation the RFN firmware needs to be configured with few 
parameters associated with the specific installation. The most important parameter is an 
ID number associated with the specific nozzle it is mounted on. The configuration is 
performed utilizing a special HHT (Hand Held Terminal) device. The detailed 
procedure is contained in the user manual of the HHT. 

RFN Battery Connector