Lutron Electronics Company Inc 0027 ユーザーズマニュアル
1
P R E L I M I N A R Y — N O T F O R R E L E A S E
Please Read Before Installing
System Bridging Timeclock
TM
RA-SBT, RB-SBT
120/127 V 50/60 Hz (18 V / 0.3 A adapter)
120/127 V 50/60 Hz (18 V / 0.3 A adapter)
Installation Instructions
Overview
The System Bridging Timeclock (SBT) bridges two
RadioRA systems, providing a total of 64 Zone Controls
and 24 Master Controls. The SBT also provides an
RS-232 interface, contact closure inputs, and an astro-
nomic time clock.
RadioRA systems, providing a total of 64 Zone Controls
and 24 Master Controls. The SBT also provides an
RS-232 interface, contact closure inputs, and an astro-
nomic time clock.
Each SBT covers approximately 2500 square ft.
(232 m
(232 m
2
) of living space.
Up to 3 RF Signal Repeaters may be used with the SBT
for each system to extend the communications range.
for each system to extend the communications range.
Important Notes
Codes: Install in accordance with all local and
national electrical codes.
national electrical codes.
Power: Use only the adapter provided by Lutron with
the SBT.
the SBT.
Caution - Using an adapter not rated for
the following specifications could damage
the SBT and possibly overheat the adapter.
the following specifications could damage
the SBT and possibly overheat the adapter.
• Input: 120/127 V 50/60Hz
• Output: 18 V / 0.3 A Class 2
• Output: 18 V / 0.3 A Class 2
Environment: Ambient operating temperature:
0-40°C, 32-104°F, 0-90% humidity, non-condensing.
Indoor use only.
0-40°C, 32-104°F, 0-90% humidity, non-condensing.
Indoor use only.
Cleaning: To clean, wipe with a clean damp cloth.
DO NOT use any chemical solutions. Do not paint
the SBT.
DO NOT use any chemical solutions. Do not paint
the SBT.
Mounting: DO NOT ground the SBT. DO NOT
mount the SBT in a metal enclosure.
mount the SBT in a metal enclosure.
RF Device Placement: Master Controls and Zone
Controls that are to be controlled by the SBT must
be located within 30 ft. (9 m) of the SBT or an RF
Signal Repeater.
Controls that are to be controlled by the SBT must
be located within 30 ft. (9 m) of the SBT or an RF
Signal Repeater.
Setup: The SBT will not function until it is addressed
and programmed. See the System Bridging
Timeclock Setup and Programming Guide.
and programmed. See the System Bridging
Timeclock Setup and Programming Guide.
RA-SBT
RB-SBT
RB-SBT