HID Global Corporation X001800D ユーザーズマニュアル
©
2010
HID
Global
Corporation
All
rights
reserved
Installing Blank Cards into the Card Hopper (DTC4500)
Using the Single and Dual Hopper
Caution: Do not run the cards with a contaminated, dull or uneven surface through the
Printer.
Step
Procedure
1
Pre-instruction.
• Printing onto such cards will ultimately lead to poor print quality and will
greatly reduce the life of the Printhead. Card Types include PVC or PVC
finish.
finish.
• Cards eject into the Output Hopper or Reject Hopper.
• Each Hopper holds 100 cards.
• The DTC4500 is available with two (2) Hopper configurations: Single and
Dual Hopper
• Certain types of smart card chips are raised slightly above the cards
surface which may result in poor color transfer. Design the card with white
space surrounding the chip. (Note: The Fargo DTC4500 Printer is capable
of printing single load cards and multiple feed cards (batch mode).)
space surrounding the chip. (Note: The Fargo DTC4500 Printer is capable
of printing single load cards and multiple feed cards (batch mode).)
• To print using single feed, simply remove all cards from the Card Hopper,
leave the Card Hopper door closed and place a card in the single Feed
Card Slot (which can be used repeatedly).
Card Slot (which can be used repeatedly).
•
Again, the cards should be loaded with the print side down and (if
applicable) the magnetic strip up and towards the front of the Printer.
applicable) the magnetic strip up and towards the front of the Printer.
DTC4500 Card Printer/Encoder User Guide
19