Trimble Inc. 8262090 ユーザーズマニュアル
3
Configuration
1 8
SNRx10 Radio Modem User’s Guide
3.1
Introduction
The Trimble WinFlash software is a Microsoft® Windows®-based application that
configures members of the SNRx10 series of radios for use in a wireless data
network.
configures members of the SNRx10 series of radios for use in a wireless data
network.
Note – SNRx10 data radios used as rover radios as part of a Trimble grade control
system are configured using the system’s interface.
system are configured using the system’s interface.
The following sequence of steps is typical of a full SNRx10 radio-modem
configuration procedure:
configuration procedure:
1.
For an SNRx10 containing two or more modules, select the module to be
configured. See 3.8 Change active radio, page 31
configured. See 3.8 Change active radio, page 31
2.
Select the data transfer protocol the radio will use. See 3.7 Change radio
protocol, page 30.
protocol, page 30.
3.
Configure the radio. See 3.3 Configure radio, page 20.
4.
Configure the radio’s serial data port(s). See 3.4 Configure ports, page 25.
5.
Confirm the radio configuration. See 5.3 Retrieve radio diagnostic information,
page 44.
page 44.
3.2
Establishing a WinFlash connection
C
CAUTION – Make sure the radio and computer power supply is sufficient to complete the task
of configuring the radio, and that all cables are secure. Breaking the connection between the
radio and the computer part way through the configuration procedure, because of a loss of
power or a cable disconnection, leaves the radio in an unusable state.
of configuring the radio, and that all cables are secure. Breaking the connection between the
radio and the computer part way through the configuration procedure, because of a loss of
power or a cable disconnection, leaves the radio in an unusable state.
The physical connection to your radio is made using service cable PN 40942-03. This
cable allows you to connect your computer and a power supply to the radio. Once the
radio is connected to your computer and a power supply then you can connect to the
radio’s internal firmware using WinFlash.
cable allows you to connect your computer and a power supply to the radio. Once the
radio is connected to your computer and a power supply then you can connect to the
radio’s internal firmware using WinFlash.
To establish a WinFlash connection to your radio, complete the following steps:
1.
Connect the I/O DB-9 connector of the service cable to a serial port on your
office computer.
office computer.
2.
Connect the 3-pin power connector to the power adapter (PN 38483).
3.
Connect the 8-pin Bendix connector to the radio.
DRAFT