Trimble Inc. 613 ユーザーズマニュアル
802.11g Wireless LAN+BT SiP combo Module V2.2
All rights are reserved by USI. No part of this technical document can be reproduced in any form without permission of USI.
Preliminary release for evaluation, Subject to be changed without Notice
•
Power
•
GND
10.2. HOST INTERFACE
The host interface will be compatible with CompactFlash (PCMCIA) standard, 16 bit I/O bus.
Signals which are not used won’t be routed to the physical interface (connector). The host
interface of Combo SiP Bluetooth portion is compliant with UART interface, the default baud
rate setting is 115.2kbps and the optional range is from 9.6kbps to 921.6kbps.
Signals which are not used won’t be routed to the physical interface (connector). The host
interface of Combo SiP Bluetooth portion is compliant with UART interface, the default baud
rate setting is 115.2kbps and the optional range is from 9.6kbps to 921.6kbps.
On Board connector
Molex 53794-0608 or 55560-0607
[Socket, 60 pins, with positioning protection, stack
height which is able to support 1.5 mm]
height which is able to support 1.5 mm]
Datasheet_Molex_53
794-0608.pdf
Datasheet_Molex_55
560-0607.pdf
Host System:
Host System Connector
Molex 54722-0607 [Header, 60 pins, with positioning protection, stack height 1.5mm]
Datasheet_Molex_54
722-0607.pdf
Pin definition
[ … ] means optional function of the pin.
PD : Signal pull down internally in the chip by 50K ohm while initialization.
PU : Signal pull up internally in the chip by 100K ohm while initialization.
5VT: 5 Volt tolerance pin
xxx_B : Signal pins end with _B are “active high”
PD : Signal pull down internally in the chip by 50K ohm while initialization.
PU : Signal pull up internally in the chip by 100K ohm while initialization.
5VT: 5 Volt tolerance pin
xxx_B : Signal pins end with _B are “active high”
Pin
Number
Definition
Draft Description
Type
WM-BG-
MR-01
CF+ interface
1
GND
GND
GND
2
D03
HD3
Data Input/Output line constitute a bi-directional
bus. HD[15:0] are used to access the MODULE
bus. HD[15:0] are used to access the MODULE
O, PD, 5VT, 4mA