Hughes Network Systems 38HL-001 ユーザーズマニュアル
1027145 – 0001 Revision D
Installing ODUs 4–17
Hub installation
1.
Make sure the antenna is right side up.
On the back of the antenna is a label with an arrow that
points to the top of the antenna. (The label reads “Install
antenna this way up.”)
points to the top of the antenna. (The label reads “Install
antenna this way up.”)
2.
The antenna bracket can point to the left or right, as shown
in figure 4-12. Before attaching the antenna to the antenna
mount, make sure the bracket orientation (to the left or
right) is suitable for your installation location. If necessary,
you can use a 5/32–inch hex key wrench to remove the
eight set screws and reinstall the bracket so it points in the
opposite direction.
in figure 4-12. Before attaching the antenna to the antenna
mount, make sure the bracket orientation (to the left or
right) is suitable for your installation location. If necessary,
you can use a 5/32–inch hex key wrench to remove the
eight set screws and reinstall the bracket so it points in the
opposite direction.
Figure 4-12
The antenna bracket can be oriented to
mount to the antenna mount on the left or right.
T0006010
Antenna
bracket
bracket
Antenna (rear view)
Set screws (8)
Some antenna models may be smaller
than the antenna shown here.
than the antenna shown here.
4.7
Attaching the
antenna to the
mount
antenna to the
mount