JVC KENWOOD Corporation 371301 ユーザーズマニュアル

© B62-2022-00 (M)

09 08 07 06 05 04 03 02 01 00

OCXO UNIT

INSTRUCTION MANUAL

• Do not drop the unit.

• Aviod jarring the unit, causing vibrations or strong impacts.

• Do not expose the unit to rain or moisture; to prevent fire or electric shock.

• Do not open the unit under any circumstances; to avoid risk of electric

shock.

• Do not expose the unit to long periods of direct sunlight, nor place it close to

heating appliances.

• Do not place the unit in excessively dusty and/or humid areas, nor on

unstable surfaces.

  FCC WARNING

 This equipment generates or uses radio frequency energy. Changes or

modifications to this equipment may cause harmful interference unless the

modifications are expressly approved in the instruction manual. The user

could lose the authority to operate this equipment if an unauthorized change

or modification is made.

 ◆

 Government law prohibits the operation of unlicensed radio transmitters

within the territories under government control.

 ◆

 Illegal operation is punishable by fine and/or imprisonment.

 ◆

 Refer service to qualified technicians only.

  INFORMATION TO THE DIGITAL DEVICE USER REQUIRED BY THE FCC

 This equipment has been tested and found to comply with the limits for a

Class B digital device, pursuant to Part 15 of the FCC Rules. These limits

are designed to provide reasonable protection against harmful interference

in a residential installation.

 This equipment generates, uses and can generate radio frequency energy

and, if not installed and used in accordance with the instructions, may

cause harmful interference to radio communications. However, there is no

guarantee that the interference will not occur in a particular installation.

 If this equipment does cause harmful interference to radio or television

reception, which can be determined by turning the equipment off and on,

 the user is encouraged to try to correct the interference by one or more of

the following measures:

 •  Reorient or relocate the receiving antenna.

 •  Increase the separation between the equipment and receiver.

 •  Connect the equipment to an outlet on a circuit different from that to which

the receiver is connected.

 •  Consult the dealer for technical assistance.

:  The following unpacking information is for use by your Kenwood 

dealer, an authorized Kenwood service center, or the factory.

Carefully unpack the unit. We recommend that you identify the items listed

in the following table before discarding the packing material. If any items are

missing or have been damaged during shipment, file a claim with the carrier

immediately.

Panhead sems screw W

N67-3008-XX

5

Flat cable

E37-1405-XX

1

Lead wire with mini pin plug

E31-3269-XX

1

Lead wire with connector

E37-1406-XX

1

Instruction Manual

B62-2022-XX

1

Please consult your dealer for installing the OCXO unit.
Note

:  When installing the OCXO unit, be sure to note the direction of the

unit.

This device complies with Part 15 of the FCC Rules. Operation is subject to

the following two conditions:
 (1) this device may not cause harmful interference, and

 (2) this device must accept any interference received, including interference

that may cause undesired operation. 

One or more of the following statements may be applicable to this equipment.

Authorized Representative in Europe:

Kenwood Electronics Europe B.V.

Amsterdamseweg 37, 1422 AC Uithoorn, The Netherlands
Manufacturer:

Kenwood Corporation

1-16-2 Hakusan, Midori-ku, Yokohama-shi, Kanagawa,

226-8525 Japan

KXK-3

UNITE OCXO

MODE D'EMPLOI