JVC KENWOOD Corporation 474601 ユーザーズマニュアル

1

◆  This repeater is intended for use as a fi xed base station with 

the antenna located outdoors on the rooftop or on an antenna 
tower.

◆  This repeater is designed for a 13.6 V DC power source!  

Never use a 24 V DC or higher source to power the repeater. 

◆  Use only the supplied DC cord.
◆  Do not remove the ferrite core attached to the DC cord. Doing 

so may cause interference with radio communications.

Note:   The following unpacking information is for use by your 
KENWOOD dealer, an authorized KENWOOD service center, or the 
factory.

Carefully unpack the repeater. We recommend that you identify 
the items listed in the following table before discarding the 
packing material. If any items are missing or have been damaged 
during shipment, fi le a claim with the carrier immediately.

Front glass

B10-2781-XX

1

Dressed screw

N08-0563-XX

1

Bracket

J29-0725-XX

2

Flat head machine screw

N32-4008-XX

4

Handle

K01-0421-XX

1

DC cord

E30-3427-XX

1

Lead wire with connector (15 pin)

E31-3228-XX

1

Fuse (15 A)

F52-0042-XX

1

SYNC Cable

E30-7701-XX

1

Instruction Manual

B5A-0713-XX

1

To install the handles onto the front panel of the repeater, align 
the handles with the holes on the front panel, then secure the 
handles using the supplied screws.

Please consult your dealer for installing the repeater and 
antenna.

Connect an optional KMC-30, KMC-35, KMC-9C, or KMC-53 
KENWOOD microphone to the MICROPHONE jack on the front 
panel.

The OCXO unit (KXK-3) is an Oven Controlled Crystal Oscillator 
(OCXO) unit.

◆  Government law prohibits the operation of unlicensed radio 

transmitters within the territories under government control.

◆  Illegal operation is punishable by fi ne and/or imprisonment.
◆  Refer service to qualifi ed technicians only.

This equipment generates or uses radio frequency energy.  Changes 
or modifi cations to this equipment may cause harmful interference 
unless the modifi cations are expressly approved by the party 
responsible/JVC KENWOOD. The user could lose the authority to 
operate this equipment if an unauthorized change or modifi cation is 
made.

This equipment has been tested and found to comply with the limits 
for a Class B digital device, pursuant to Part 15 of the FCC Rules. 
These limits are designed to provide reasonable protection against 
harmful interference in a residential installation.

This equipment generates, uses and can generate radio frequency 
energy and, if not installed and used in accordance with the 
instructions, may cause harmful interference to radio communications. 
However, there is no guarantee that the interference will not occur 
in a particular installation. If this equipment does cause harmful 
interference to radio or television reception, which can be determined 
by turning the equipment off and on, the user is encouraged to try to 
correct the interference by one or more of the following measures:

 • 

Reorient or relocate the receiving antenna.

 • 

Increase the separation between the equipment and receiver.

 • 

Connect the equipment to an outlet on a circuit different from that to 
which the receiver is connected.

 • 

Consult the dealer for technical assistance.

We are grateful you purchased this KENWOOD repeater.  We 
believe this easy-to-program repeater will be highly effective in 
your communications system, and will keep personnel operating 
at peak effi ciency.

KENWOOD incorporates the latest in advanced technology into 
all of our products.  As a result, we feel strongly that you will be 
pleased with the quality and features of this product.

• 

Do not expose the unit to rain or moisture; to prevent fi re or 
electric shock.

• 

Do not open the unit under any circumstances; to avoid risk 
of electric shock.

• 

Do not expose the unit to long periods of direct sunlight, nor 
place it close to heating appliances.

• 

Do not place the unit in excessively dusty and/or humid 
areas, nor on unstable surfaces.

• 

Do not put the plastic bag used for packing of this equipment 
on the place which reaches a small child's hand. It will 
become a cause of suffocation if it wears fl atly.

• 

Always switch the transceiver power off before installing 
optional accessories.

• 

If you detect an abnormal odor or smoke coming from the 
unit, disconnect the power from the unit immediately.  Contact 
your KENWOOD service center or dealer.

The title to and ownership of copyrights for fi rmware embedded in 
KENWOOD product memories are reserved for JVC KENWOOD 
Corporation.

The AMBE+2

TM

 voice coding Technology embodied in this product 

is protected by intellectual property rights including patent rights, 
copyrights and trade secrets of Digital Voice Systems, Inc.  This 
voice coding Technology is licensed solely for use within this 
Communications Equipment.  The user of this Technology is 
explicitly prohibited from attempting to extract, remove, decompile, 
reverse engineer, or disassemble the Object Code, or in any other 
way convert the Object Code into a human-readable form. U.S. 
Patent Nos. #6,199,037, #6,912,495, #8,200,497, #7,970,606, and 
#8,359,197.

◆  Do not install the repeater in explosive atmospheres 

(infl ammable gas, dust particles, metallic powders, grain 
powders, etc.).